Assembly Instructions

SLT-AH Series Adjustable Height Science Lab Table Instructions

The SLT-AH Series has been designed with the capability to be used with

both our standard non-book compartment style table or with book

compartments (purchased separately). Note: Extra apron marked BC is

for use with book compartments only. For optional book compartment

units, proceed to pg. 2 for book compartment installation instructions

which should be done prior to leg installation.

Follow the below instructions for installation of adjustable legs.

Tools Required:Power screw driver with philips head

Step 1: Place the tabletop upside-down on the floor with apron side up.

Note: Floor should be clear of any objects or dirt in order not to damage

the tabletop.

Step 2: Carefully remove each of the four height adjustable legs from

second carton and align holes on leg mounting plate with pre-drilled

holes at the four corners of the underside of the table.

Step 3: Using a screw driver, carefully install each of the four legs with

the provided screws (6- screws per leg) and tightly secure each of the

screws.

Step 4: Attach a glide to the bottom of the each leg by inserting the

threaded end of the glide into the threaded hole on the bottom of the

leg.

Step 5: Turn the table over with the tabletop facing up. Place the table

in desired location. Adjust the glides to assure that table is stable.

PAGE 1
SLT-AH Series Adjustable Height Science Lab Table Instructions The SLT-AH Series has been designed with the capability to be used with both our standard non-book compartment style table or with book compartments (purchased separately). Note: Extra apron marked BC is for use with book compartments only. For optional book compartment units, proceed to pg. 2 for book compartment installation instructions which should be done prior to leg installation.
PAGE 2
Book compartment installation instructions. Removing Standard Apron Panel Place the tabletop with apron side up on a clean surface. Note: Surface should be clear of any objects or dirt to avoid any damage to tabletop. Using a screwdriver, begin by removing one front apron panel from tabletop in the following manner:    Remove the screws that secure the apron panel to the tabletop (see figure A) Remove the screws that secure the front apron panel to the brackets.
PAGE 3
For optional caster installation, unscrew glides and tightly screw casters to bottom of legs. CAUTION: Double check all screws to be tightened securely before use. Check all screws periodically. Instructions for table height adjustment 1. For incline use, stand at one side of table, place feet on extended portion of glides and lift to desired height. Legs will automatically lock in place. See Ill. 1. For full table adjustment, repeat this at other side of table. 2.