Assembly Instructions_2

Double check all screws to be ghtened securely before use. Check all screws periodically.
CAUTION:
Fig. A
Removing Standard Apron Panel
Place the tabletop with apron side up on a clean surface.
Note: Surface should be clear of any objects or dirt to avoid any damage to tabletop.
Using a Philips screwdriver begin by removing one front apron panel from tabletop in the following
manner:
 Remove the screws that secure the apron panel to the tabletop (see gure A)
 Remove the screws that secure the front apron panel to the brackets.
 Remove the screws from the two apron panel reinforcement bars and remove the reinforcement bars.
SLT Series Science Lab Table
Book Compartment Assembly Instrucons
Fig. B
Fig. C
Screw
reinforcement
bars into
tabletop
Fig. E
Installing Book Compartment Apron Panel
Remove apron panel marked BC from tabletop carton and install onto tabletop in the following manner:
 Insert the grooves on the apron panel into the two steel corner braces where the original apron was
located and secure with six screws.
 Further secure apron by inserng the screws from the front panel into the tabletop.
Installing Book Compartments
Place book compartments upside down on the tabletop and insert the boom rmly into the grooves on
the apron panel (see gure D)
Using a Philips screwdriver, fasten twelve screws (for each compartment) into the holes of the book
compartment reinforcement bars. (see gure E)
Fig. D
Fit book compartment
into grove in BC panel
www.nationalpublicseating.com