Instructions / Assembly

National Tree Company 2 Commerce Drive, Cranford, New Jersey 07016 • www.nationaltree.com
SAVE THESE INSTRUCTIONS
Note: All products will need some amount
of branch shaping before final display.
These products include small trees, porch
bushes, teardrops, centerpieces and
similar items. Wreath and garland images
are used to illustrate this point.
SHAPING
The product is shipped from the factory
with the branch tips compressed to the
center. Each branch tip must be shaped to
its proper position to give the product a
natural look. This will also bring the piece to
its advertised dimension. The care and
attention given to this final process will
result in a genuinely beautiful and
appealing holiday decoration.
Shaping is done by gently grasping the
branch tips and spreading them out away
from the center. The BEFORE photo shows
the product as it appears out of the box.
The AFTER photo shows how the product
should look after proper shaping.
BEFORE AFTER
BEFORE AFTER
BATTERY INSTALLATION
Open battery compartment and insert batteries observing
proper polarity (
+
/–).
OPERATION
Pressing the ON/OFF button once will turn on the lights and
begin the timer. The timer will run continually: 6 hours with lights
on, then 18 hours with lights off and repeat until deactivated by
pressing ON/OFF button.
DUAL COLOR LIGHTS (if equipped)
Continue to press the button to sequence through the nine light
functions: steady warm white; steady multicolor; fading warm
white; fading multicolor; warm white fading to multicolor;
flashing warm white; flashing multicolor; flashing warm white to
multicolor (slow); flashing warm white to multicolor (fast).
STORAGE
To avoid leakage and corrosion, remove batteries from battery
compartment before storage. Store product in a cool, dry
location, protected from sunlight.
WARNINGS
• This product is for seasonal decoration only and not intended
for permanent installation or use.
• Do not mix old and new batteries. Replace all batteries at the
same time.
• Do not mix alkaline, standard (carbon-zinc), or rechargeable
(nickel-cadmium) batteries or equivalent.
• Do not use rechargeable batteries.
• Do not dispose of batteries in fire. Batteries may explode and
cause injury.
CAUTION: changes or modifications not expressly approved by the party
responsible for compliance could void the user’s authority to operate the
equipment.
NOTE: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses
and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
– Reorient or relocate the receiving antenna.
– Increase the separation between the equipment and receiver.
– Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
– Consult the dealer or an experienced radio/TV technician for help.
BULB REPLACEMENT INSTRUCTIONS (if equipped)
1. Pull up on the Bulb Lock unlatching the bulb from the bulb socket.
Gently pull the bulb straight out.
2. Carefully insert new bulb into socket (bulb is keyed and only goes in
one way) and push down Bulb Lock until it snaps into place.