Instructions / Assembly

Customer Service Hotline: [phone]-TREE
National Tree Company 2 Commerce Drive, Cranford, New Jersey 07016 • www.nationaltree.com
SAVE THESE INSTRUCTIONS
CAUTION: IMPORTANT SAFETY INSTRUCTIONS
READ AND FOLLOW ALL SAFETY INSTRUCTIONS
• Do not use seasonal products outdoors
unless marked suitable for indoor and
outdoor use. When products are used
i
n outdoor applications, connect the
product to a Ground Fault Circuit
Interrupter (GFCI) outlet. If one is not
provided, contact a qualified electrician
for proper installation.
• This seasonal use product is not intend-
e
d for permanent installation or use.
• Do not mount or place near gas or
electric heaters, fireplaces, candles or
other similar sources of heat.
• Do not secure the wiring of the product
with staples or nails, or place on sharp
hooks or nails.
• Unplug the product when leaving the
house, when retiring for the night, or if
left unattended.
• Do not let lamps rest on the supply cord
or any wire.
• CAUTION: This is an electrical product
– not a toy! To avoid risk of fire, burns,
personal injury and electric shock, it
should not be played with or placed
where small children can reach it.
•
Do not use this product for other than its
intended use.
• Do not hang ornaments or other objects
from cord, wire or light string.
• Do not close doors or windows on the
product or extension cords as this may
damage the wire insulation.
• Never operate this product if the power
cord or plug is damaged.
• Use only manufacturer specified
replacement bulbs.
• Read and follow all instructions that are
on the product or provided with the
product.
USE AND CARE INSTRUCTIONS
•
Before using or reusing, inspect product
carefully. Discard any products that have
cut, damaged, or frayed wire insulation
or cords, cracks in the lamp holders or
enclosures, loose connections, or
exposed copper wire.
• When storing the product, carefully
remove the product from wherever it is
placed, avoiding any undue strain or
stress on the product conductors,
connections, and wires.
• When not in use, store neatly in a cool,
dry location protected from sunlight.
Bulb Replacement
1. Unplug light string from power source.
2. Pull up on the Bulb Lock (if equipped) unlatching the bulb from
the bulb socket. Gently pull the bulb straight out (Figure 1).
3. Before inserting the new bulb into socket, make
sure that the two wires on either side of the the
bulb base are straight up and flush with the base
(diagram at right).
4. Carefully insert new bulb into socket and push
down Bulb Lock (if equipped) until it snaps into
place (Figure 2).
Fuse Replacement
1. Unplug light string from power source.
2. Fuses are located in light string plug. Slide the fuse access cover
away from cord side (in direction of arrow, Figure 3) exposing
fuses.
3. Remove fuses from compartment and examine. Replace burnt
out fuse with new one.
4. Close fuse compartment by sliding access cover back in towards
cord side of plug (Figure 4).
Fig. 3 Fig. 4
Fig. 1 Fig. 2