User Manual

3. Press Button 8 (OK) to export the Slices.
→ The Slices will be mapped to individual notes of the selected Sound, starting with the
bottom C (C-2 in MASCHINE convention). The base key of the Sound will be set to the
bottom C as well (see section ↑5.1.3, Adjusting the Base Key for more information on the
base key). Any previous content in the Sound will be replaced. Your controller will leave
Sample mode and return to Control mode. The pads will switch to Keyboard mode so that
you can directly play your Slices on the pads. Additionally, depending on the setting of
the Pattern Creation selector in the Slice page of the software, notes will be automatically
created for each Slice (see above for more information).
To export the Slices to a Group:
1. Select the desired Group by pressing its Group button A–H. If your Project has more than
eight Groups, you can use Button 3 and 4 to first select the desired Group bank.
The selected Group button starts flashing and the corresponding Group is highlighted on
the left display.
2. Press Button 8 (OK) to export the Slices.
→ The Slices will be mapped to individual Sound slots, replacing their current content (if
any). Only the first 16 Slices will be exported. Your controller will leave Sample mode and
return to Control mode. The pads will switch to Group mode so that you can directly play
your Slices on the pads. Additionally, depending on the setting of the Pattern Creation se-
lector in the Slice page of the software, notes will be automatically created for each Slice
(see below).
At any time you can press Button 7 (CANCEL) to cancel the export and return to the
SLICE page.
Exporting a Single Slice
Instead of exporting all Slices, you can also export the selected Slice only:
1. Press Button 7 (APPLY TO).
The controller switches to the Selection mode described above.
2. Press Button 5 (SINGLE) to export the selected Slice only.
3. Choose the target Sound or Group as described above.
Sampling and Sample Mapping
Slicing a Sample
MASCHINE - Manual - 858