User Manual
Table Of Contents
- Title Page
- Disclaimer
- Contact
- Table of Contents
- 1 Introduction
- 2 Basic Concepts
- 3 Browser
- 4 Sound Slots
- 5 Creating Groups
- 6 Working with Patterns (Hardware)
- 6.1 Creating Patterns
- 6.1.1 Pattern Mode
- 6.1.2 Pad Mode
- 6.1.3 Pad Link
- 6.1.4 Releasing a Pad from a Pad Link Group
- 6.1.5 Recording the Pads
- 6.1.6 The Metronome
- 6.1.7 Using the Step Sequencer
- 6.1.8 Using Note Repeat
- 6.1.9 Using the Piano Roll/Keyboard
- 6.1.10 Recording Automation
- 6.1.11 Recording Automation in the Step Sequencer
- 6.1.12 Step Grid, Pattern Length Grid and Quantization
- 6.2 Editing Patterns
- 6.1 Creating Patterns
- 7 Working with Patterns (Software)
- 7.1 The Pattern Editor
- 7.2 Editing Patterns
- 7.2.1 Mouse Actions in the Pattern Editor
- 7.2.2 The Zoom Tool
- 7.2.3 Compare/Split
- 7.2.4 The Piano Roll / Keyboard
- 7.2.5 Recording and Editing Automation
- 7.2.6 Adding a Modulator
- 7.2.7 Step Grid, Pattern Length Grid and Quantization
- 7.2.8 Pad Link
- 7.2.9 Releasing a Pad from a Pad Link Group
- 7.2.10 Setting up a Pad as Master or Slave in a Pad Link Group
- 7.2.11 Rendering Audio from Patterns using Drag and Drop
- 7.2.12 Rendering MIDI from Patterns using Drag and Drop
- 8 The Effects Overview
- 9 Using FX
- 9.1 Applying Effects to a Sound
- 9.2 Applying Effects to a Group
- 9.3 Applying Effects to the Master
- 9.4 Bypassing Effects
- 9.5 Automating Effects and Sampler Parameters
- 9.6 Applying FX to an External Instrument
- 9.7 Recording FX Automation
- 9.8 Saving FX Presets
- 9.9 Creating a Send Effect
- 9.10 Creating a Multi Effect
- 10 Creating a Song using Scenes
- 11 Sampling and Sample Mapping
- 12 The Master Section
- 13 Exporting Audio
- 14 Appendix: Tips for playing Live
- Index
Amplitude Envelope Controls
Sustain Sustain determines the constant level being kept after Decay until the note
ends. This can also be controlled by an external MIDI controller or key-
board using MIDI CC 64.
Release Release determines how long the sound takes to fade out after the note
has ended.
4.2.3 Page 3: FX and Filter Settings
Sampler FX settings on the hardware.
Sampler FX settings on the software.
FX
This is a small selection of basic FX, not to be mixed up with the FX section covered in depth
in chapter ↑8, The Effects Overview.
FX Controls
Comp Basic compressor allowing you to give a Sound more density.
Drive Defines the amount of saturation applied to a Sound.
SR SR stands for sample rate: you can use it to lower the original sample rate
in order to make the Sound more lo-fi.
Bits Allows you to lower the original bit rate of the Sound, resulting in a more
rough, digital sounding lo-fi effect.
Sound Slots
The Sampler Parameters in Module 1
MASCHINE - Manual - 67