User Manual

You will notice that once you have pasted the Sound, the target button starts to blink, indicat-
ing that it is ready to be pasted again to additional Sound slots: Therefore, to duplicate a
Sound more than once, once you have pressed the source button you only have to press all the
desired target buttons in a row.
If your Project contains more than eight Groups, use the D-pad Left or Right buttons to
access other Group banks.
Instead of holding DUPLICATE, you can also pin Duplicate mode by pressing DUPLI-
CATE + SONG [PIN]. You can then release DUPLICATE: Your controller will stay in Du-
plicate mode until you press DUPLICATE again. See section ↑5.1, Controller Modes and
Mode Pinning for more information.
7.4.9 Duplicating Patterns
You can copy and paste Patterns in your Project within the same Group or to another Groups
using MASCHINE JAM.
On your controller in the Project view, do the following to copy a Pattern from slot to another:
1. Press the SONG button to enter Song mode.
▪ An overview of all your Scenes and Patterns is provided.
2. Press and hold DUPLICATE.
3. Press the Pattern button you want to copy.
▪ The click-pad containing the Pattern starts blinking.
4. Select the target the Group (A–H) if you want to copy the Pattern to another Group.
5. Press the click-pad of the target Pattern slot.
→ An exact duplicate of the Pattern will be copied. The copied Pattern will replace any Pat-
tern previously loaded in the target slot.
You will notice that once you have pasted the Pattern, the target slot starts to blink, indicating
that it is ready to be pasted again to additional Pattern slots: Therefore, to duplicate a Pattern
more than once you only need to press all the desired target click-pads in a row.
Recording and Editing Patterns
Editing a Pattern
MASCHINE JAM - Manual - 123