User Manual
Table Of Contents
- Title Page
- Disclaimer
- Contact
- Table of Contents
- Welcome to KOMPLETE KONTROL
- Basic Concepts
- KOMPLETE KONTROL and KOMPLETE KONTROL S-SERIES
- Adjusting the KOMPLETE KONTROL Software Interface
- Loading Instruments
- Stand-Alone and Plug-in Mode
- MIDI Mode
- Preferences
- Connecting External MIDI Equipment to KOMPLETE KONTROL S-SERIES
- Incoming and Outgoing MIDI
- Native Map
- Controlling Parameters via MIDI and Host Automation
- Using Pedals with KOMPLETE KONTROL S-SERIES
- Quick Start
- KOMPLETE KONTROL Software Overview
- KOMPLETE KONTROL S-SERIES Overview
- KOMPLETE KONTROL Browser
- Browser Basics
- Searching and Loading Files from the Library
- Loading and Importing Files from Your File System
- Saving Files to the User Library
- Displaying and Editing File Information
- Browsing with the KOMPLETE KONTROL S-SERIES
- Browse Mode and Hardware Browsing
- Hardware Browsing
- Browser Overview
- Choosing Between Factory and User Content via the On-Screen Overlay
- Selecting a Product via the On-Screen Overlay
- Selecting a Bank via the On-Screen Overlay
- Filtering by Types via the On-Screen Overlay
- Filtering by Modes via the On-Screen Overlay
- Using the Result List in the On-Screen Overlay
- Filtering by Favorites via the On-Screen Overlay
- Adding and Removing Favorites
- KOMPLETE KONTROL Smart Play
- Troubleshooting – Getting Help
- Index
When you skip to another page, the knobs are mapped to another set of parameters and the
displays reflect the new mapping. At any point, you can tap a knob to see the set value of the
mapped parameter.
You can customize the parameter mapping for each preset in the Plug-in Panel of the
KOMPLETE KONTROL software. For more information, see section ↑4.3, Plug-in Panel.
Not only the knobs and displays are mapped to instrument parameters via Native Map: also
KOMPLETE KONTROL S-SERIES’ touch strips are mapped automatically. For information
about the touch strips, see section ↑5.6, Touch Strips. For information on how to control in-
strument parameters, continue reading below.
5.5.3 Controlling Instrument Parameters with the Control Section
Once you have loaded an instrument into KOMPLETE KONTROL you can control its parame-
ters with the KOMPLETE KONTROL S-SERIES keyboard (for information on how to browse and
load instruments, see section ↑6.6, Browsing with the KOMPLETE KONTROL S-SERIES). The
section below describes how to control instruments and their parameters with the Control sec-
tion.
▪ In the following example, we have loaded the preset 3Saw from the instrument MONARK.
◦ This is reflected by the PRESET display at the far left of the Control section, which
reads 3SAW:
Preset 3SAW
▪ In the KOMPLETE KONTROL software, this is reflected by the preset display in the header:
KOMPLETE KONTROL S-SERIES Overview
Control Section
KOMPLETE KONTROL - Manual - 106