User Manual

ative, see below). This mode mimics the behavior of the Pitch Strip (see section ↑5.6.1,
Pitch Strip). In Spring mode, the following additional settings are available for the Modula-
tion Strip:
◦ Display menu: Lets you select one of two ways to display the current state of the Mod-
ulation Strip: Bar or Dot. Bar displays a bar of lit LEDs from the default position of the
strip to the current value; whereas Dot displays a dot of lit LEDs at the current value.
◦ Strength slider: Adjusts the rate at which the spring rebounds to its default position.
The higher the Strength setting, the quicker the value will spring back to its default
position.
◦ Touch Ctl menu: Lets you select between Absolute (default behaviour) and Relative.
When using Relative, the current value of the controlled parameter is preserved when
you put your finger anywhere on the Modulation Strip. You can then move your finger
up and down to change the parameter by the corresponding amount.
▪ Ball: This mode simulates a ball that is attracted by the gravity of your finger. The current
position of the ball (the parameter value) is indicated by a blue LED. If you put your finger
on the strip, the ball will move towards your finger and stop as it reaches the finger’s posi-
tion. If you remove your finger before, the ball sustains its momentum and continues to
move along the Modulation Strip until the friction of the surface causes it to slow down and
stop. Alternatively, you can “throw” the ball by putting your finger on the ball’s current po-
sition, dragging it in any direction, and removing your finger. The faster you drag your fin-
ger, the faster the ball will get. In Ball mode, the following additional settings are available
for the Modulation Strip:
◦ Display menu: Lets you select one of two ways to display the current state of the Mod-
ulation Strip: Bar or Dot. Bar displays a bar of lit LEDs from the default position of the
strip to the current value; whereas Dot displays a dot of lit LEDs at the current value.
◦ Friction slider: Adjusts the friction of the surface that slows down the ball once you
have removed your finger. The higher the Friction value, the quicker the ball will de-
celerate and stop. When fully left, the ball never stops. When fully right, the ball stops
instantly.
◦ Gravity slider: Adjusts the attraction of your finger on the ball: The higher the Gravity
value, the faster the ball will move. This parameter doesn’t affect the ball movement if
you throw the ball with your finger (see above).
KOMPLETE KONTROL S-SERIES Overview
Touch Strips
KOMPLETE KONTROL - Manual - 120