User Manual
Table Of Contents
- Title Page
- Disclaimer
- Contact
- Table of Contents
- Welcome to KOMPLETE KONTROL
- Basic Concepts
- KOMPLETE KONTROL and KOMPLETE KONTROL S-SERIES
- Adjusting the KOMPLETE KONTROL Software Interface
- Loading Instruments
- Stand-Alone and Plug-in Mode
- MIDI Mode
- Preferences
- Connecting External MIDI Equipment to KOMPLETE KONTROL S-SERIES
- Incoming and Outgoing MIDI
- Native Map
- Controlling Parameters via MIDI and Host Automation
- Using Pedals with KOMPLETE KONTROL S-SERIES
- Quick Start
- KOMPLETE KONTROL Software Overview
- KOMPLETE KONTROL S-SERIES Overview
- KOMPLETE KONTROL Browser
- Browser Basics
- Searching and Loading Files from the Library
- Loading and Importing Files from Your File System
- Saving Files to the User Library
- Displaying and Editing File Information
- Browsing with the KOMPLETE KONTROL S-SERIES
- Browse Mode and Hardware Browsing
- Hardware Browsing
- Browser Overview
- Choosing Between Factory and User Content via the On-Screen Overlay
- Selecting a Product via the On-Screen Overlay
- Selecting a Bank via the On-Screen Overlay
- Filtering by Types via the On-Screen Overlay
- Filtering by Modes via the On-Screen Overlay
- Using the Result List in the On-Screen Overlay
- Filtering by Favorites via the On-Screen Overlay
- Adding and Removing Favorites
- KOMPLETE KONTROL Smart Play
- Troubleshooting – Getting Help
- Index
Dynamic
The second OTHER parameter, Dynamic, is only available in Arp mode. On the keyboard it is
mapped to Knob 7 of the Control section when ARP EDIT mode is selected. It reads the veloci-
ty of the input—e.g. a key you pressed on your KOMPLETE KONTROL S-SERIES keyboard or
an incoming MIDI note from your host software—and scales it by the factor you set with the
Dynamic parameter. The scaling is applied per note. The velocity of each played note is taken
and multiplied by the value set with the Dynamic parameter.
Dynamic is a drag control that lets you set a value between 1.0% and 200.0%.
To display the set value of the DYNAMIC parameter, tap Knob 7.
Gate
The third OTHER Parameter, Gate, is available in both Arp and Note Repeat mode. On the key-
board, it is mapped to Knob 8 of the Control section when ARP EDIT mode is selected. It lets
you decide the length of the notes in your sequence. Setting a value between 1% and 99%
makes the duration of the notes shorter than they otherwise would be. Setting a value between
101% and 200% instead elongates the duration of the notes by the selected value.
Gate is a drag control that lets you set a value between 1.0% and 200.0%.
To display the set value of the GATE parameter, tap Knob 8.
7.7.4 Advanced
The ADVANCED parameters Retrigger, Repeat, Offset, and Inversion allow you to explore alter-
native versions of the same Arp sequence.
KOMPLETE KONTROL Smart Play
Arp Parameters
KOMPLETE KONTROL - Manual - 234