User Manual

You can customize the parameter mapping for each preset in the Plug-in Panel of the
KOMPLETE KONTROL software. For more information, see section ↑4.3, Plug-in Panel.
2.10 Controlling Parameters via MIDI and Host Automation
When you load KOMPLETE KONTROL as a plug-in into your host application, the parameters
of the loaded instrument that are currently mapped to the knobs and displays on KOM-
PLETE KONTROL S-SERIES also become available for automation from your host.
Which KOMPLETE KONTROL Parameters Can Be Automated?
All the parameters available for automation are found in the Perform Panel or in the loaded
instrument. You cannot automate the controls located in the Browser as they do not send MIDI
and therefore cannot be found by your host application. This means that only parameters that
are assigned to the knobs and displays on your KOMPLETE KONTROL S-SERIES via either Na-
tive Map or MIDI CC can be automated.
For more information about assigning controls via MIDI, please refer to the Controller
Editor documentation in the software installation folder on your hard disk
In turn, you can also use your KOMPLETE KONTROL S-SERIES to control your host applica-
tion. This is described in section ↑5.4, Host Control and the Transport Section.
2.10.1 Recording Automation
Many DAWs require that you have set transport record to on (see section ↑5.4.1, Transport
Controls) in order to record automation, while others make use of dedicated automation con-
trols.
For detailed information regarding automation recording in your DAW, refer to the docu-
mentation of your host software.
To record automation data in your host using KOMPLETE KONTROL, you can take the follow-
ing measures:
Basic Concepts
Controlling Parameters via MIDI and Host Automation
KOMPLETE KONTROL - Manual - 55