Installation Sheet

ManualsBrandsNative Trails ManualsBathroom SinksMaestro 15-3/4" Single Basin Vessel Copper Bathroom Sink

TABLE OF CONTENTS

A. General Installation Notes

B. Drop-In and Raised Proﬁle Sink Installation

C. Undermount Sink Installation

D. Vessel Sink Installation

E. Apron Front Sink Installation

F. Wall Mount Vanity Installation

G. Bathtub Installation

PRODUCT INSTALLATION INSTRUCTIONS

2015 | nativetrails.net

Summary of content (5 pages)

PAGE 1
2015 | nativetrails.net PRODUCT INSTALLATION INSTRUCTIONS TABLE OF CONTENTS A. General Installation Notes B. Drop-In and Raised Profile Sink Installation C. Undermount Sink Installation D. Vessel Sink Installation E. Apron Front Sink Installation F. Wall Mount Vanity Installation G.
PAGE 2
READ THIS FIRST A. GENERAL INSTALLATION NOTES: • All Native Trails products should be installed by a licensed contractor • Observe and comply with all building and plumbing codes. • As our basins are handcrafted and dimensions are approximate, we recommend using the actual basin for the cutout. • Use 100% Silicone (non-water based) for all installations. • Ensure adequate space behind the basin for faucet and backsplash, including the full range of motion for faucet handles and spouts.
PAGE 3
C. UNDERMOUNT SINK INSTALLATION: If vanity top is pre-cut go to Step 4. UNDERMOUNT 1. Use actual basin as your template. Place it upside down on countertop and mark countertop by tracing edge of basin. Be sure to allow clearance for faucet and other accessories or fixtures. 2. Measure inside edge of lip and mark countertop accordingly, inside of the first line. 3. Cut countertop on inside line. 4. Temporarily place basin in cut-out to verify proper fit. 5.
PAGE 4
E. APRON FRONT SINK INSTALLATION: 1. Make a template and cutout. For built-up mount, cut countertop along the outside line of basin profile. After centering the basin and allowing for faucets, handles and backsplashes, use a pencil to outline the basin as your guide for the cut-out, allowing for any reveal (if desired) before the actual cutting. Depending on the installation type, make proper cut-out in the countertop. 2.
PAGE 5
G. BATHTUB INSTALLATION: Before Installation: • Unpack and inspect the tub for damage. Place on throw rug or other protective floor covering to prevent damage to the bath or floor. • Make sure the flooring offers adequate support for the tub, and verify that the sub floor is flat and level. • Ensure proper access to the final plumbing connections. • For tub protection, position a clean drop cloth or similar material in the bottom of the tub. Be careful not to scratch the surface of the tub.