Installation Sheet

E. APRON FRONT SINK INSTALLATION:

1. Make a template and cutout. For built-up mount, cut countertop along

the outside line of basin proﬁle. After centering the basin and allowing for

faucets, handles and backsplashes, use a pencil to outline the basin as your

guide for the cut-out, allowing for any reveal (if desired) before the actual cutting.

Depending on the installation type, make proper cut-out in the countertop.

2. Create a custom support using 2x4’s that will adequately hold the weight

of the sink from underneath. We highly recommend using a professional

installer to install your Native Trails sink.

3. Place the sink on top of cabinet or into the cabinet front cut-out.

Apply silicone as a gasket between sink and cabinet.

4. Apply a bead of silicone around top edge of sink. Place countertop on the sink.

Make sure that it is centered properly. Remove any excess silicone from

the lip or any surfaces.

5. Install the drain according to the drain’s installation instructions. When cleaning

up after installation do not use abrasive cleaners, as they may scratch and

alter the sink surface and ﬁnish. Use warm water, a soft cloth and a non-abrasive

soap (such as dish soap) to clean the surface. Refer to Care and Maintenance

Instructions for further information.

F. WALL MOUNT VANITY INSTALLATION:

(Bordeaux, Halcyon, Harmony, etc.)

1. Check the speciﬁed height or determine desired height and determine where

studs are located in the wall. Wall mounting hardware can be found at any

major hardware store. (If no studs can be found, use heavy duty wall

mounting hardware to secure vanity to the wall.)

2. Drill holes for lag bolts that line up with wall studs and height of vanity

in the wooden French cleat provided. Make sure slanted edge will ﬁt

correctly into the vanity.

3. Drill pilot holes in walls and through studs so that studs will not crack

when lag bolt is tightened.

4. Screw lag bolts through wooden French cleat and into the wall making

sure it is level and at the right height to support the vanity.

5. Hang vanity on the French cleat attached to the wall.

6. Install top, sink, and drain according to installation instructions.

7. For Harmony: Ensure drawers are ﬂush and level, and that gaps are even

between drawer and vanity frame. To level drawers, adjust washer around front

screws on either side of drawer slides. Adjustments may be needed on both sides.

HARMONY SLIDES