User Manual

FCC STATEMENT (USA)

This device complies with Part 18 of the FCC Rules

WARNING: Changes or modiﬁcations to this unit not expressly approved by

the party responsible for compliance could void the user's authority to

operate the equipment.

NOTE: This equipment has been tested and found to comply with the limits

for a Class B ISM equipment, pursuant to Part 18 of the FCC Rules. These

limits are designed to provide reasonable protection against harmful

interference in a residential installation. This equipment generates, uses,

and can radiate radio frequency energy and, if not installed and used in

accordance with the instructions, may cause harmful interference to radio

communications. However, there is no guarantee that interference will not

occur in a particular installation. If this equipment does cause harmful

interference to radio or television reception, which can be determined by

turning the equipment o and on, the user is encouraged to try to

correctthe interference by one or more of the following measures:

- Reorient or relocate the receiving antenna.

- Increase the separation between the equipment and receiver.

- Connect the equipment into an outlet on a circuit dierent from that

to which the receiver is connected.

- Consult the dealer or an experienced radio / TV technician for help.

The user is cautioned that changes and modiﬁcations made to the

equipment without the approval of manufacturer could void the user’s

authority to operate this equipment.

RSS STATEMENT (CANADA)

This device contains licence-exempt transmitter(s)/receiver(s) that comply

with Innovation, Science and Economic Development Canada’s licence-ex-

empt RSS(s). Operation is subject to the following two conditions:

(1) This device may not cause interference.

(2) This device must accept any interference, including interference that

may cause undesired operation of the device.

Caution: To maintain the compliance with the RF exposure guideline,

place the unit at least 10 cm from nearby persons.