Installation Guide

Step 1: Begin installation working from
left to right. Insert spacers at ends and
edges where planks meet wall.
Step 2: Lock short end of plank by
inserting tongue into groove at an
angle and drop in place. Continue to
end of first row.
Step 3: Use leftover plank from first
row as starter for second row. There
must be at least 8” between plank end
joints on adjacent rows.*
FOR TILE INSTALLATIONS: The distance between end joints should be equal to 12” for proper appearance.
Step 4: Lock long edge of plank by
inserting tongue into groove at an
angle and drop in place. Slide plank
toward end of previously installed
plank until the tongue just touches the
groove.
Step 5: IMPORTANT! Use hammer
and tapping block to tap long edge of
plank to ensure a tight fit. ANY
GAPPING CAN COMPROMISE THE
LOCKING SYSTEM!
Step 6: Attach a scrap piece of floor to
bridge gap between ends of planks.
Step 7: Tap end of plank with hammer
and tapping block to lock ends of planks
together. Remove bridge and continue
towards wall until installing the final plank
in the row.BE SURE TO TAP ON EDGE
OF VINYL SO AS NOT TO DAMAGE
LOCKING PROFILE.
Step 8: Use hammer and pull bar to lock
final piece in row. Insert spacer at end of
row. Continue installation to final row.
Step 9: Use hammer and pull bar to
lock long edges of planks on final row.