Use and Care Manual

NATURAL CURRENT SAVIOR USE AND CARE MANUAL

Installation Use

1) Take the Savior out of the delivery box, unwrap and placing it on the surface of your in-

ground or above ground swimming pool or spa.

2) Once Savior is in the pool or spa, with the solar panel facing up and filters in the water.

3) Be sure the Savior can see direct sunlight for it to run and filter the water.

4) If you have anything in the way of sunlight within you pool water surface, then you may

tether (leash) the Savior in a sunlit area of your pool.

There is no On or Off switch. To turn off the unit, place a towel on top of the solar panel or

remove from pool or spa and gently place upside down on the ground in a shaded area.

Filter Cartridges

1) Replace Recommended Filter Cartridges: Unicel 7CH-322

2) Other Filter Cartridges Options: Pleatco PAS35-2, Filbur FC-0420

3) Filter Cartridge Model Size: Please look and see for your particular model size for your

Savior unit.

Filter Cartridges Care

Tell when a Filter Cartridge needs to be replaced

In a typical spa, the culprit that plugs the media is perspiration and body oils combined with soaps,

chemicals and very fine particulate. In a swimming pool, the loading is primarily debris along with

suntan lotions and organic matter such as algae.

Assuming the Filter is properly maintained, determining when the Filter Cartridge is exhausted

depends primarily upon three factors:

1) Shorter cycle time between cleanings

2) Low water flow rate,

3) Catastrophic failure such as a tear in the media or center core collapse.

PAGE 1
NATURAL CURRENT SAVIOR USE AND CARE MANUAL Installation Use 1) Take the Savior out of the delivery box, unwrap and placing it on the surface of your inground or above ground swimming pool or spa. 2) Once Savior is in the pool or spa, with the solar panel facing up and filters in the water. 3) Be sure the Savior can see direct sunlight for it to run and filter the water.
PAGE 2
All three are dependent upon proper pool or spa water chemistry and following a routine maintenance schedule. Filter elements are plastic and should be handled and maintained accordingly.
PAGE 3
Submersible Filter Pump Motor Pump Replace Recommended Pump Motor Type: Rule Marine by Xylem (Only) Rule Marine Model Size: Look and see for your particular model size in GPH New Pump Installation Directions: 1) Pull the Savior out of the water and flip it upside down 2) Unclip the old pump and pull the cord out until it stops (about a foot long of cord or so) 3) Then cut the cord (two wires) leaving length/room to work and wiring together.