Full Product Manual

Solar Step Lights
21060
Locaon of the Solar Panel
For best result, posion the solar panel where it can get
direct sunlight, and is free from cover and shade. (As shown
in figure 1). The Solar Step Light should be le to charge for 2
sunny days before inial use
Operaon
1) For normal operaon, turn the switch to the “AUTO” posion, this
will automacally turn the unit ON at dusk (Shown in Figure 2)
2) The performance of the Solar Step Lights will vary during the me of
year. The light will deliver more intensity when it has had a full day of sun
rather than a day in cloudy or overcast weather.
Installaon
1) Carefully remove all the fings from the box
2) Find a suitable locaon for the Solar Step Lights, on a wall, step, or stairs..
3) Measure the width of two holes on the back of the Solar Step Light to align
holes for 2 the screws on the surface.
4) If mounng on masonry, brick, or cement, use a drill for the holes insert
wall plugs and fixing screws. Insert the wall plugs supplied so they are flush with
the surface. Insert the screws and leave at least ¼”,
or 5 mm of the screws outside
of the surface for holding the Solar Step Light.
5) Mount the Solar Step Light on the screws by placing the unit over the holes.
Replacing the Baery
1) Release the screws on the back of the unit and slide out the back cover
part.(as shown in figure 3 and figure 4)
2) Remove the old baery. Make sure the new baery is high quality Ni-Mh AAA
rechargeable baery.
3) Install the new baery in to the baery compartment, ensuring the correct
polarity is observed.
Reassemble the unit by replacing the back cover. For best results Ni-Mh baery
should be replaced every 12 months.
Trouble Shoong
If your Solar Step Light does not come on at dusk despite observance of all the instrucons, please try the
following steps:
1) Make sure the Solar Step Light is not being affected by any other light source, if this is the case move your Solar
Step Light to a locaon where there is less light interference.
2) Make sure the Solar Step Light’s solar panel is not located in the shade during the day.
3) Make sure the switch is in the AUTO posion.
4) Check that b
aery is installed correctly.
Maintenance
Clean the solar module with a damp towel to insure opmum performance of the Solar Step Light. Do not use any type
of solvent for cleaning and be careful not to put too much pressure on the module while cleaning.
Limited Warranty Proof of Purchase is Required (Receipt) Nature Power warrants our products to the original purchaser that
this product is free from defects in materials and workmanship for the period of one year from date of purchase.
Please contact Nature Power Products to acquire more informaon or technical support:
1-800-588-0590
[e-mail]
www.naturepowerproducts.com
SCREW
BATTERY COMPARTMENT
SWITCH
2
3
4