Warranty

Solar Pathway Light

21070

Instruction Manual

Features

 2 LEDs per unit

 Up to 8 Hours of Runtime on a full charge

 No Wiring Required

 Weather Resistant

 Automatic sensor turns the light on at dusk

 Includes Rechargeable Solar batteries

Location of the Solar Pathway Light

For best result, position the Pathway Light where it can

get direct sunlight, and is free from cover and shade. (As

shown in figure 1). The Solar Pathway Light should be

left to charge for 2 sunny days before initial use.

Installation Instructions

1) Carefully remove all the fittings from the box.

2) Find a suitable location for the Solar Pathway Light

3) Screw in position by “fixing bracket with 2 provided screws (as shown in figure 2)

4) Assemble Solar Pathway Light to fixing bracket by turning it clockwise (as shown in figure 3)

Operation

1) Press the switch to “AUTO” position (As show in Figure 4), it will automatically

turn the unit at dusk.

2) The performance of the Solar Pathway Light will vary during the time of year.

The light will deliver more brightness and duration of light when it has had a full

day in the sun rather than a day in cloudy or overcast weather.

Replacing the Batteries

For best results Ni-Mh batteries should be replaced every 12 months.

1) Release the screw on the back of the unit (as shown in figure 5)

2) Remove the old battery. Make sure the new battery is high quality Ni-Mh AA

rechargeable battery.

3) Install the new battery in to the battery compartment, ensuring the correct

polarity is observed.

4) Reassemble the unit by replacing the back cover.

PAGE 1
Solar Pathway Light 21070 Instruction Manual Features  2 LEDs per unit  Up to 8 Hours of Runtime on a full charge  No Wiring Required  Weather Resistant  Automatic sensor turns the light on at dusk  Includes Rechargeable Solar batteries Location of the Solar Pathway Light For best result, position the Pathway Light where it can get direct sunlight, and is free from cover and shade. (As shown in figure 1). The Solar Pathway Light should be left to charge for 2 sunny days before initial use.
PAGE 2
Trouble Shooting If your Solar Pathway Light does not come on at dusk despite observance of all the instructions, please try the following steps: 1) Make sure that the solar panel is not being affected by any other light source, if this is the case move your Decorative Solar Pathway Light where .there is less light. 2) Make sure the solar panel is not located in the shade during the day. 3) Make sure the switch is in the AUTO position.