Version 1.
Thank you very much for choosing a Nature Power Product! For future reference, please complete the owner’s record below: Model: _______________ Purchase Date: _______________ Save the receipt and these instructions. It is important that you read the entire manual to become familiar with this product before you begin using it. This product is designed for certain applications only. The distributor cannot be responsible for issues arising from modification.
FEATURES Your Solar Security Light is the perfect system for the following: • Entrance • Garage • Porch • Eaves • Emergency PARTS LIST Part# Description Qty. 1 Lamp 1 2 Solar Panel 1 3 Screws and Anchors 1 4 Mounting Bracket 1 5 Manual 1 USE AND CARE • Do not modify the Solar Light in any way. Unauthorized modification may impair the function and/or safety and could affect the life of the equipment. There are specific applications for which the Solar Light was designed.
INSTALLATION 1. Lamp Unit Installation • Use ‘U’ shaped mounting plate located to the rear of the lamp to mark where you want to install the lamp Fig 1 • Make sure this is clear of obstacles such as cables and electric lines. • Secure lamp to the wall with screws provided. • Carefully route the wire from the solar panel to the lamp and plug it into the battery housing input. • Adjust the motion sensor so that it faces the area where motion detection is desired.
OPERATION 1. Before the Solar Motion Light can operate to its full capacity, allow the unit to charge in sunlight for 3 days with the solar panel wire connected to the light.. Charging should be done with the unit in the “OFF” position. 2. Located at the bottom of the Battery Housing there is am OFF/AUTO/ON switch: • “AUTO” position, the light will turn on automatically when motion is detected. • “ON” position, the light can be used as a standard light for constant illumination.
LOCATION OF SOLAR LIGHT Solar powered lights require sunlight to recharge the internal batteries. For best results, locate the Solar Panel in a position where it will receive direct sunlight, and is generally free from cover and shade. TROUBLESHOOTING If the light does not illuminate when movement in front of the sensor is obvious, please observe the following: • Ensure the solar panel is in a location where it will receive maximum sunlight during daytime hours.
MAINTENANCE Perform a visual inspection once per season. Keep the solar panel free of dirt and debris by wiping with a damp cloth. After periods of inclement weather, and during winter, it may be necessary to place the light in the OFF position and allow the batteries to recharge. This is because the batteries may not be able to fully charge during the day during times of limited or reduced sunlight.