Instructions / Assembly

Nature Power Products
Nature Power Monocrystalline Solar Cells are manufactured in Germany by Bosch and Solar Panels are assembled in China.
Manual Printed in China
Please Read Instruction Manual before Operating
Thank you for purchasing your Nature Power Monocrystalline Solar Panel. This manual contains safety and
installation information for Nature Power Monocrystalline Solar Panels. Nature Power reserves the right to
make changes to the product, specifications and this manual without notice. Therefore, check the website for
manual updates as necessary. www.naturepowerproducts.com
Cautions
• Never touch the end of output cables with your bare hands when the modules are irradiated. Handle wires
with rubber-gloved hands to avoid electric shock
• Do not wear metallic jewelry when working on electrical equipment
• Product should be installed and maintained by qualified personnel
• Do not drop tools or other items on the glass of the solar module
• Do not scratch the back film of the solar panel
• Avoid exposing solar panels to partial sunlight or shadows. Partial sunlight can cause hot spots on the panel
• Do not pour chemicals on module when cleaning. To clean use a damp cloth do not apply excessive
pressure to the cells
• Do not expose solar module to sunlight concentrated with mirrors, lenses or similar means
• Keep module away from children
Precautions when working with batteries
• Never smoke or allow a spark or flame near the batteries
• Batteries generate hydrogen and oxygen during charging resulting in evolution of explosive gas mixture.
Care should be taken to ventilate the battery area and follow the battery manufacturer’s recommendations
• Batteries contain very corrosive diluted acid as electrolyte. Precautions should be taken to prevent contact
with skin, eyes or clothing
• Use caution to reduce the risk of dropping a metal tool on the battery. It could spark or short circuit the
battery or other electrical parts and could cause an explosion
• Remove metal items like rings, bracelets and watches when working with batteries. The batteries can
produce a short circuit current high enough to weld a ring or the like to metal and thus cause a severe burn
• If you need to remove a battery, always remove the ground terminal from the battery first. Make sure that
all the accessories are off so that you do not cause a spark
• Only use rechargeable 12 Volt batteries, ie. Sealed Lead Acid, Deep Cycle, Gel-Cell etc.
• Use properly insulated tools only when making battery connections
• When working with batteries please follow the battery’s manufacturer manual and precautions
Precautions when working with solar panels
With the incidence of sunlight or other light sources on all solar panels, a voltage appears at the output
terminals of the solar panel turning it into a source of electricity. Do not make contact with the terminals when
the panel is exposed to sunlight or other light sources. To avoid shock hazard make sure the solar panel is
either turned over so the cells are not exposed to light or cover the cells with an opaque (dark) material such as
paper/cloth during the installation process.