Use and Care Guide

Installation
1. Open the packaging and check to make sure that all parts have been received.
2. Arrange to have on hand the proper tools to carry out the mounting installation.
3. Determine the mounting location of the solar panel(s). It is important the solar panel receive the
maximum amount of sunlight during the day and not be shaded.
4. Connecting solar panel to battery for 12V charging.
5. Mount the charge controller within 5 feet of battery or loss of current may occur.
6. Wire the battery to the charge controller and then the solar panel to the charge controller to ensure
that the correct polarity is observed.
7. Secure the solar panel to the desired location, solar panel must be within 20 feet of the battery, or
loss of current may occur.
Page 4 of 10
Technical Specifications
Pmax
90W 165W
330W(
Voltage at Pmax (Vmp)
17.5V 17.5V
*kit consists of
2 165W panels*
Current at Pmax (Imp)
5.14A 9.43A
Open Circuit Voltage
(Voc)
21.6V 21.0V
Short Circuit Current (Isc)
5.49A 9.95A
Dimension
32.6x26.5x1.2”
57.8x26.5x1.4”
Efficiency
18.2% 17.20%
Cell technology
Class
Weight
21.1lbs 25.3lbs
180W
17.5V
10.3A
21.0V
9.95A
57.8x26.5x1.4”
18.9%
25.3lbs
Monocrystalline
100W
17.5V
5.71A
21.6V
5.49A
32.6x26.5x1.2”
19.85%
A
21.1lbs
Rated electrical characteristics are within +10 percent of the indicated values of lsc, Voe, Pmax under
Standard Test Conditions (irradiance of 100 mW/cm 2, AM 1.5 spectrurn, and a cell temperature of
25℃ {77°F}). The electrical characteristics are based on the results of outgoing test.
Reference Part Description Quantity
Parts List
11
Solar panel with SAE connector wiring
11
2
3
SAE-Battery clamp cable
Mounting Z bracket set
1
4