Instructions / Assembly

Precheck
NOTE: Do not connect to the battery.
Spin rotor shaft slowly with your fingers
while at the same time connecting and
disconnecting the DC OUTPUT's positive
and negative wires. With the wires
connected, the rotor shaft should become
more difficult to rotate. With the wires
disconnected, it should spin freely.
Red wire
Every time connect the DC
OUTPUT's wires (RED= Positive,
BLACK = Negative)
directly to the set of posts of the
battery, the controller LED will
lighten to indicate that the
controller is running properly.
CAUTION: DO NOT CONNECT WIND
AC in put
DC output
-
+
Black wire
Red wire
GENERATOR POSITIVE TO BATTERY
NEGATIVE AND CHARGE CONTROLLER
NEGATIVE TO BATTERY POSITIVE FOR
EVEN A SECOND, OR ELSE WILL DAMAGE
THE WIND GENERATOR'S CONTROLLER
AND VOID YOUR WARRANTY.
NOTE: THIS UNIT COMES WITH AN AUTO-ADJUSTING 12V/24V
FUNCTION, IT IS COMPATIBLE WITH 12V OR 24V SYSTEMS FOR
CHARGING 12V OR 24V BATTERIES. IT WILL AUTO SET FROM THE
BATTERY ONCE CONNECTED, IF CONNECTED TO 12V BATTERY THE
CHARGE CYCLE WILL SET FOR 12V AND IF CONNECTED TO 24V
BATTERY IT WILL SET CHARGE CYCLE TO 24V.