Instructions / Assembly
How to Recharge Your Nature’s Power Pod
Recharging from Solar
1. Place your solar panel where it will get as much direct sunlight as possible. While direct sunlight
is always preferred, solar panels should be connected at all mes to provide a consistent trickle
charge to your baery. Solar panels will also send a charge your unit while in hazy or overcast
skies.
2. Insert solar panel plug into Solar Input port on the front of Nature's Power Pod. You will know it
is recharging when LED lights start running. The LED lights remain solid when the baery is full or
there is not enough power from solar panel.
3. It takes about 15 to 20 hours to recharge Nature's Power Pod if using 100 wa solar panel,
depending on the strength of the sunlight.
4. To increase the recharging speed, you can chain mulple solar panel in parallel connecon. The
Solar Input port can handle up to 200 wa solar panel. Visit Naturesgenerator.com for informaon
on purchasing addional Nature’s Generator Solar Panels.
Recharging from Nature’s Generator
1. Connect Nature's Power Pod to Nature’s Generator (not included in the box) by the expansion
cord.
2. When Nature’s Generator is being recharged by solar, wind or wall, Nature's Power Pod will be
recharged at the same me.
3. The LED lights do not run while Nature’s Power Pod is recharged from Nature’s Generator, but
you always can press the LED Light Buon to check baery level.
Recharging from the Car
You can use DC extension cord (not included in the box) to recharge the Nature's Power Pod by
using 12V DC port. This method is not recommended because it recharges much slower.
Using Your Nature’s Power Pod
6
Visit Naturesgenerator.com for More Information