Operations and Maintenance Manual
Table Of Contents
- Release control record
- Section 1: Description
- Section 2: Operating the transmitter
- User Interfaces
- Viewing Transmitter Log
- Viewing AUI Tool Menu Panels
- Viewing Real-Time Meters
- Managing Presets
- Enabling Remote Control
- Resetting Alarms
- Viewing Transmitter Status
- System Settings
- System Settings - Front Panel UI
- Setting User Accounts
- User Settings - AUI
- User Settings - Front Panel UI
- Configuring Remote Inputs and Outputs
- Scheduler
- Audio Player
- Enabling and Operating the Orban Audio Processor
- Figure 2-1 : VS Transmitter Front Panel Display Menu Tree (Sheet 1 of 2)
- Figure 2-2 : VS Transmitter Front Panel Display Menu Tree - Edit Presets (Sheet 2 of 2)
- Figure 2-3 : VS Transmitter AUI Flow Diagram
- Section 3: Routine maintenance
- Section 4: Non-standard maintenance
- Section 5: List of terms
VS300 Operations and Maintenance Manual Operating the transmitter
Page 2-114 Issue 10.0 2019-01-18
Firmware Update
A firmware update is available using the front panel UI. It can also be performed from the
remote AUI, using the
Upgrade Software
page in the
System Settings
menu (see “Upgrading
Software” on page 2-101). Once the host (SBC) is reset, all users that were remotely connected
(logged in) will be logged out.
From the front panel UI, you can update firmware used in the transmitter. To perform a
firmware update, select
System Settings -> Firmware Update
from the
Main Menu
(see
Figure 2.97).
Figure 2.97: System Settings - Firmware Update
LCD Settings
From the front panel, you can configure the LCD display’s contrast, brightness and backlight
settings. To view the
LCD Settings
screen, select
System Settings -> LCD Settings
from the
Main
Menu
(see Figure 2.98).
Figure 2.98: System Settings - LCD Settings Menu
Note:
LCD Settings are only available using the front panel UI.