Operations and Maintenance Manual
Table Of Contents
- Release control record
- Section 1: Description
- Section 2: Operating the transmitter
- User Interfaces
- Viewing Transmitter Log
- Viewing AUI Tool Menu Panels
- Viewing Real-Time Meters
- Managing Presets
- Enabling Remote Control
- Resetting Alarms
- Viewing Transmitter Status
- System Settings
- System Settings - Front Panel UI
- Setting User Accounts
- User Settings - AUI
- User Settings - Front Panel UI
- Configuring Remote Inputs and Outputs
- Scheduler
- Audio Player
- Enabling and Operating the Orban Audio Processor
- Figure 2-1 : VS Transmitter Front Panel Display Menu Tree (Sheet 1 of 2)
- Figure 2-2 : VS Transmitter Front Panel Display Menu Tree - Edit Presets (Sheet 2 of 2)
- Figure 2-3 : VS Transmitter AUI Flow Diagram
- Section 3: Routine maintenance
- Section 4: Non-standard maintenance
- Section 5: List of terms
VS300 Operations and Maintenance Manual Operating the transmitter
Page 2-116 Issue 10.0 2019-01-18
Configuring Installed Hardware
From the front panel UI, you can configure the transmitter for any installed hardware that has
optional variations (e.g., quantity of exciters or LVPS modules, fan speed) or is non-standard
(e.g., audio processor). To view the
HW Config
screen, select
System Settings -> HW Config
from the
Main Menu
(see Figure 2.100).
Figure 2.100: System Settings - HW Config Menu
This menu has two sub-menu options:
• Installed Exciter - see page 2-117
• Audio Processor - see “Enabling and Operating the Orban Audio Processor” on page 2-
184
Note:
Hardware configuration settings are only available using the front panel UI.
These settings are established at the factory based on the configuration that existed
at time of shipping. Changes to these setting are only necessary if hardware is
added or removed by the user.