Operations and Maintenance Manual

VS300 Operations and Maintenance Manual Operating the transmitter
Page 2-144 Issue 10.0 2019-01-18
Setting the Clock
The VS300’s internal clock uses a backup battery, and therefore maintains an accurate date and
time, even during power outages. The date and time needs to be set when the transmitter is
first installed, or after a power outage if the backup battery has failed.
You can set the date and time using the remote AUI (see Setting the Clock - Using the AUI) or
the local front panel UI (see Setting the Clock - Using the Front Panel on page 2-146). If you
change the clock setting on the front panel UI, it will also be reflected on the remote AUI, and
vice versa. If the NTP feature is enabled (see Setting the Clock - Using the Front Panel on
page 2-146), the clock will set automatically and cannot be manually adjusted.
Setting the Clock - Using the AUI
You can remotely set the VS300’s time and date using the AUI’s
Time Setup page (see
Figure 2.120 on page 2-144) by selecting
Time Setup from the User Settings options or by
clicking on the date or time, which is displayed in the upper, left corner of the AUI.
Figure 2.120: User Settings - Time Setup