Operations and Maintenance Manual
Table Of Contents
- Release control record
- Section 1: Description
- Section 2: Operating the transmitter
- User Interfaces
- Viewing Transmitter Log
- Viewing AUI Tool Menu Panels
- Viewing Real-Time Meters
- Managing Presets
- Enabling Remote Control
- Resetting Alarms
- Viewing Transmitter Status
- System Settings
- System Settings - Front Panel UI
- Setting User Accounts
- User Settings - AUI
- User Settings - Front Panel UI
- Configuring Remote Inputs and Outputs
- Scheduler
- Audio Player
- Enabling and Operating the Orban Audio Processor
- Figure 2-1 : VS Transmitter Front Panel Display Menu Tree (Sheet 1 of 2)
- Figure 2-2 : VS Transmitter Front Panel Display Menu Tree - Edit Presets (Sheet 2 of 2)
- Figure 2-3 : VS Transmitter AUI Flow Diagram
- Section 3: Routine maintenance
- Section 4: Non-standard maintenance
- Section 5: List of terms
VS300 Operations and Maintenance Manual Operating the transmitter
Issue 10.0 2019-01-18 Page 2-173
Figure 2.147: Remote Inputs Screens (Input 1 shown)
Use the up and down buttons to select the desired remote input (1 through 10) from the list.
Each screen shows the current remote input parameter (e.g.,
RF On/Off
), as well as the polarity
(e.g.,
Falling edge RF On
) and current state (e.g., high, low) of the corresponding input pin. Use
the right-arrow button to enter the
Selection/Polarity
screen for the selected input to allow
editing of the selection or the polarity. Press cancel (
X
) to return to the previous menu.
If you save a change to a remote input via the front panel UI, it will also be displayed on the
AUI page.
Remote Outputs - Front Panel
Using the
Remote Outputs
screens (see Figure 2.148), you can configure up to 16 remote
outputs that indicate either the presence of various alarms or the status of operator controlled
circuits.
Nautel sets remote output defaults prior to shipping. See the VS300 Pre-installation Manual for
details.
Note:
The selection and polarity options for remote inputs are the same as described in
Select Input Channel - AUI on page 2-163 and Configure Input control logic -
AUI on page 2-164.