Operations and Maintenance Manual
Table Of Contents
- Release control record
- Section 1: Description
- Section 2: Operating the transmitter
- User Interfaces
- Viewing Transmitter Log
- Viewing AUI Tool Menu Panels
- Viewing Real-Time Meters
- Managing Presets
- Enabling Remote Control
- Resetting Alarms
- Viewing Transmitter Status
- System Settings
- System Settings - Front Panel UI
- Setting User Accounts
- User Settings - AUI
- User Settings - Front Panel UI
- Configuring Remote Inputs and Outputs
- Scheduler
- Audio Player
- Enabling and Operating the Orban Audio Processor
- Figure 2-1 : VS Transmitter Front Panel Display Menu Tree (Sheet 1 of 2)
- Figure 2-2 : VS Transmitter Front Panel Display Menu Tree - Edit Presets (Sheet 2 of 2)
- Figure 2-3 : VS Transmitter AUI Flow Diagram
- Section 3: Routine maintenance
- Section 4: Non-standard maintenance
- Section 5: List of terms
VS300 Operations and Maintenance Manual Operating the transmitter
Issue 10.0 2019-01-18 Page 2-185
Configuring the Transmitter for the Orban Audio Processor
Configure the VS300 to recognize the presence of the Orban card using the front panel UI as
follows:
1. With the transmitter turned on and in local mode of operation, navigate to the front
panel UI's
Main Menu -> System Settings
-> HW Config
menu. Scroll down through
this menu and select
Audio Processor
(see Figure 2.159).
2. In the
Audio Processor
screen (see Figure 2.159), use the up and down buttons to toggle
between
None
and
Orban Inside
(default factory seting is
None
). Select
Orban Inside
to
enable the Orban audio processor for use (selecting
None
disables it). Press the accept
(checkmark) button to save the change. Press cancel (
X
) to discard changes and return
to the previous menu.
3. Reboot the transmitter by switching the ac power off and then on. This will ensure the
transmitter properly detects the Orban Inside card upon recovery.
Figure 2.159: Configuring the Transmitter - HW Config / Audio Processor Screens
Note:
Audio processor configuration is only available using the front panel UI.