Technical Instruction
Table Of Contents
- Nautel Limited
- MODULE EXCHANGE SERVICE
- 6.1 INTRODUCTION
- 6.2 WIRING LISTS NOT PROVIDED
- 6.3 PRINTED WIRING PATTERNS
- 6.4 WIRE COLOURS
- 5.5 WIRING LISTS PROVIDED
- 7.1 INTRODUCTION
- 7.2 COMPONENT VALUES
- 7.3 GRAPHIC SYMBOLS
- 7.4 LOGIC SYMBOLS
- 7.5 REFERENCE DESIGNATIONS
- 7.5.1 Types of Inputs/Outputs
- 7.5.2 Logic Level/Convention
- 7.7 IDENTIFICATION OF SCHEMATIC DIAGRAMS
Page 2-4 VSHD Exciter Technical Instruction Manual
Issue 2.0 Section 2 Installation
2.2.3.2 Rack Slider Assembly
Assemble the Rack Slider as follows:
• Separate the slider assembly parts ‘A’ and “B” by pressing the quick release button
and pulling apart. See Figure 2-2.
Figure 2-2: Slider Assembly Release
• Assemble parts ‘C’, ‘D’ and ‘E’, of the rack mount assembly. Tighten hardware
connecting parts ‘D’ and ‘E’. Leave the hardware connecting parts ‘C’ and ‘D’ finger
tight to allow for rack depth adjustment. When the rack depth is known, tighten the
hardware and repeat for the opposite side. See Figure 2-3.
Figure 2-3: Rack Slider Assembly
• Attach part ‘A’ of the rack slider to rack mount assembly parts ‘C’, ‘D’ and ‘E’. Repeat
for the opposite side and tighten all hardware. See Figure 2-4.