Technical Instruction
Table Of Contents
- Nautel Limited
- MODULE EXCHANGE SERVICE
- 6.1 INTRODUCTION
- 6.2 WIRING LISTS NOT PROVIDED
- 6.3 PRINTED WIRING PATTERNS
- 6.4 WIRE COLOURS
- 5.5 WIRING LISTS PROVIDED
- 7.1 INTRODUCTION
- 7.2 COMPONENT VALUES
- 7.3 GRAPHIC SYMBOLS
- 7.4 LOGIC SYMBOLS
- 7.5 REFERENCE DESIGNATIONS
- 7.5.1 Types of Inputs/Outputs
- 7.5.2 Logic Level/Convention
- 7.7 IDENTIFICATION OF SCHEMATIC DIAGRAMS
Page 2-6 VSHD Exciter Technical Instruction Manual
Issue 2.0 Section 2 Installation
2.2.3.3 Mounting the Slides
• Install the slide bracket on the screws against the back of the nut retainers (if used)
and install securing hardware ‘M’, ‘N’, and ‘O’. Secure the rack mount assembly to
the rack rear using four ‘A’ screws and ‘M’, ‘N’, and ‘O’ securing hardware. Tighten
all hardware. See Figure 2-6.
NOTE
Front screws may have been installed in the previous step.
Figure 2-6: Mounting the Slides