User Manual

19
7. ToadjusttheBraketension,loosenthe2hexheadbolts
(C) and move the Servo Motor assembly (D) until the closest
pointontheBrakeMagnet(A)iswithin3.0mm(1/8”)ofthe
Flywheel (B). Tighten the bolts.
Note: If the cardboard is not 3mm (1/8”) thick, you can
use the pages of a paperback book to measure
thegap.Approximately36pages(sheets)=3mm.
8. Turn the power on again. Use the console to check the
resistance adjustment.
Machine is on. Current is active. There is risk of
electrical shock.
Note: Before fully attaching the Shrouds, remove the
cardboardfrombetweentheBrakeMagnet(A)and
the Flywheel (B). Power up the machine to verify
thattheMagnetArmcanmovefreely,andthatthe
Brake Magnet and Flywheel do not touch.
9. Final Inspection
Inspect your machine to ensure that all hardware is tight and
components are properly assembled.
!
Do not use until the machine has been fully
assembled and inspected for correct performance
in accordance with the Owner’s Manual.
B
D
A
C