User Manual

Note: Your machine may not match the image. For reference only.

1. Placeastaticobject(likeabookorbox)underthefront

stabilizer(C).Thestaticobjectshouldnotbecompressible.

2. Using a short #2 Phillips screwdriver, loosen and remove

thescrews(A1)fromtheFootpad(A),andsetthemsafely

aside.RemovetheFootpadfromthefrontstabilizer(D).Set

the Footpad and screws safely aside.

3. Loosen and remove the screw (B1) from the Endcap

assembly (B) and set it safely aside. Remove the Endcap

fromthefrontstabilizer(D).SettheEndcapandscrewsafely

aside.

4. Usingthe6mmhexkeyand13mmwrench,loosenand

remove the hardware (C1) from the old Transport Wheel

assembly (C). Remove the old Transport Wheel from the

frontstabilizerbracket(D1).SettheTransportWheeland

hardware safely aside.

5. Installation is the reverse procedure.

NOTICE: Before fully attaching the Endcap, be sure that

the Transport Wheel can turn freely.

6. Dispose of the old parts.

7. Final Inspection

Inspect your machine to ensure that all hardware is tight and

components are properly assembled.

Do not use until the machine has been fully

assembled and inspected for correct performance

in accordance with the Owner’s Manual.