User Manual

Note: Your machine may not match the image. For reference only.

1. RemovetheSeatPostandtheSeatAdjustmentKnob(A).

Set them safely aside for reassembly.

2. Usingaatheadscrewdriver,removethethreadedCap(B)

fromtheCrankArm(C)toexposetheHexHeadBolt(D).

3. Usingawrenchandsocket,removetheHexHeadBolt(D).

4. ThreadtheCrankPullerintotheCrankArm(C).Whenthe

CrankPullerisinthecorrectposition,only1-2threadsonthe

outer portion (CP2) of the Crank Puller should show.

Note: Be sure the end of the Bolt (CP1) of the Crank Puller is

ushwiththeNut(CP2)asshown,beforeuse.

5. Using a wrench, turn the inner portion (CP3) of the Crank

Pullerclockwise.TheCrankArm(C)willslideoffasitis

tightened.

Go to Step 8.

6. Twist the Crank Cover (P) toward the front of the machine

to disengage the inner tabs. Carefully remove the Crank Covers

and set them safely aside.

Disconnect all power to the machine before you service it.

CP1 CP2 CP3