User Manual

41
11. Put the Handlebar in the bracket, adjust the Handlebar to
thedesiredangle,andinstalltheT-handlethroughtheholes
and washers.
NOTICE: Do not crimp the cables.
12. Use the pull cable in the Handlebar Bracket to route the
HR cable and Resistance cable through the slot under the
Handlebar Bracket to the top of the mast. Fully tighten the
T-handletokeeptheHandlebarinposition.Pushthecover
into position on the Handlebar Bracket.
NOTICE: Do not crimp the cables. Do not let the cables
fall down in the Mast.
13. Connect the cables to the back of the Console and
attach the Console to the Mast.
NOTICE: Do not crimp the cables.
14. Final Inspection
Inspect your machine to ensure that all hardware is tight and
components are properly assembled.
!
Do not use until the machine has been fully
assembled and inspected for correct performance
in accordance with the Owner’s Manual.