User Manual
50
13. Reinstall the Mast, Console, Mast Gasket and Top
Shroud. (Refer to the “Replace the Shrouds” procedure.)
Turn the power on.
Machine is on. Current is active. There is risk of
electrical shock.
14. Use the console to set the resistance to the highest
level. Unplug the machine.
Disconnect all power and allow to sit for 5
minutes.
15. PuttheBrakeArm(K)backinpositionandconnectthe
Tension Spring (J) using the needlenose pliers.
Note: Before fully attaching the Shrouds, remove the
cardboardfrombetweentheBrakeMagnet(A)
and the Flywheel (B). Power up the machine to
verifythattheMagnetArmcanmovefreely,and
that the Brake Magnet and Flywheel do not touch
atthemaximumresistancelevel.Ifnecessary,
refer to the “Set the Brake Tension” procedure.
16. Final Inspection
Inspect your machine to ensure that all hardware is tight and
components are properly assembled.
!
Do not use until the machine has been fully
assembled and inspected for correct performance
in accordance with the Owner’s Manual.