User Manual

NOTICE: It is necessary to remove the Shrouds for this procedure. Refer to the “Replace the Shrouds” procedure.

It is necessary to adjust the Drive Belt tension at the end of this procedure. Refer to the “Belt Tension Adjustment” procedure

Note: Your machine may not match the image. For reference only.

1. Carefully remove the Shrouds. Refer to the “Replace the

Shrouds” procedure in this manual.

2. MarkthepositionoftheBeltTensioner(A)ontheMain

Frame bracket (D) to record the angle of the Tension Spring

arm’s position.

3. Slowly turn the Drive Pulley (B) backward and carefully

ease the Drive Belt (C) off the Drive Pulley to the outside.

Be sure to keep ngers clear of all pinch

hazards as you turn the Drive Pulley.

4. Using needlenose pliers, release the Tension Spring

(A1)fromthehook(H)ontheMainFrame.

5. Using13mmwrenchand6mmhexkey,loosenand

remove the Belt Tensioner Hardware (E). Remove the Belt

Tensionerassembly(A)fromtheMainFrameandtheDrive

Belt (C). Discard the old Belt Tensioner assembly.

6. InstallthenewBeltTensionerassembly.Adjustthe

Belt Tensioner position to the angle of the previous position

recorded in Step 2.

NOTICE: Do not overtighten the hardware (E). The

Belt Tensioner must be able to pivot. If the

hardware is too tight, this can cause wear on

the bearings.

7. Put the Drive Belt (C) onto the Drive Pulley (B). Make

sure the Drive Belt is aligned on the Flywheel pulley (F),

BeltTensioner(A)andDrivePulley.Besurethattheupper

portion of the Drive Belt is under the bearings on the Belt

Tensioner.

8. Using needlenose pliers, attach the Belt Tensioner

spring(A1).Makesurethatthebelttensioniscorrect.Refer

tothe“BeltTensionAdjustment”sectioninthismanual.

Note: This step may require two people.

9. Final Inspection

Inspect your machine to ensure that all hardware is tight and

components are properly assembled.

Do not use until the machine has been fully

assembled and inspected for correct performance

in accordance with the Owner’s Manual.

Disconnect all power to the machine before you service it.