User Manual

CONSOLE SETUP MODE

The Console Setup Mode lets you input the date and time, set the units of measurement to either English or Metric,

control the sound settings ( on/ off), or see maintenance statistics (Error Log and Run Hours ± for service technician use

only).

1. Hold down the PAUSE/END button and Up arrow button together for 3 seconds while in the Power-Up Mode to go

into the Console Setup Mode.

Note: Push PAUSE/END to e[it the Console Setup Mode and return to the Power-Up Mode screen.

2. The Console display shows the Date prompt with the current setting. To change, push the Up/Down arrow buttons to

adjust the currently active value (Àashing). Push the Left/Right buttons to change which segment is the currently ac-

tive value (month / day / year).

3. Push OK to set.

4. The Console display shows the Time prompt with the current setting. Push the Up/Down arrow buttons to adjust the

currently active value (Àashing). Push the Left/Right buttons to change which segment is the currently active value

(hour / minute / AM or PM).

5. Push OK to set.

. The Console display shows the Units prompt with the current setting. To change, push OK to start the Units option.

Push the Up/Down arrow buttons to change between “MILES” (Imperial English units) and “KM” (metric units).

Note: If the units change when there is data in User Statistics, the statistics convert to the new units.

7. Push OK to set.

8. The Console display shows the Sound Settings prompt with the current setting. Push the Up/Down arrow buttons to

change between “ON” and “OFF”.

9. Push OK to set.

10. The Console display shows the TOTAL RUN HOURS for the machine.

11. For the ne[t prompt, push the OK button.

12. The Console display shows the Software 9ersion prompt.

13. For the ne[t prompt, push the OK button.

14. The Console will display the Power-Up Mode screen.