Complete Components List o o o o o o o o o o o o o s s s s s s o o o o o o o o o o o o o 1
Hardware Size Chart #8 Qty: 2 #9 Qty: 2 #14 Qty: 2 #10 Qty: 4 #12 #13 Qty: 2 Qty: 2 #11 Qty: 2 Required Tools: 2
step 1 Step #1 Materials: 3
step 2 Step #2 Materials: 4
step 3 B F C D E G A 6 F 5a 7 18 11 Step #3 Materials: Description Qty. 5a 6 7 9 11 18 Pec Pad Collar Pec Fly Pad Seat Back Cap Screw - 3/8" x 2.75"L 3/8" Washer 5/16" Set Screw (Preassembled) 2 2 1 2 2 2 TM Slide the PEC FLY PAD (6) onto the Right Pec Arm Assembly (A) and secure with a PEC PAD COLLAR (5a) and a 5/16" SET SCREW (18). Tighten all hardware. Repeat step A for the Left Pec Arm Assembly. A. # 9 B. C. Remove the Lat Cable (G) from the Lat Cable Termination Assembly (B).
step 4 I F H E D G 2e C B J 2c A Cable Termination Detail A. Step #4 Materials: # Description Qty. 2c 2e Floating Pulley Bracket Assembly Pec Cable (w/ Terminations) 1 1 Thread the Lat Cable (A) into the FLOATING PULLEY BRACKET ASSEMBLY (2c) Remove the cable termination from both ends of the PEC CABLE (2e) by removing the Button Head Cap Screw (B), Spacer (C), U-Bracket (D), 2 - Washers (J), and Nut (E). Attach the PEC CABLE (2e) to the Left Cam Assembly (F) using the given hardware.
Lubrication and Final Check A. Lubricate Guide Rods using a silicon based lubricant. B. Carefully inspect all cables and insure that they are properly seated on the pulleys and that they pass between the cable stops and pulleys. C. Double check all hardware and make sure everything is tightened properly. Cable Tensioning A. Tighten the Cable System using the combination of four adjustment locations. These locations are the Double Floating Pulley Brackets and the Selector Rod Top Plate Assembly.
