Operation Manual

37
Nospeed/RPMreading,
Consoledisplays“E3”error
code
Checkdatacableintegrity Allwiresincableshouldbeintact.Ifanyarecut
or crimped, replace cable.
Checkdatacableconnections/
orientation
Makesurecableisconnectedsecurelyand
orientedproperly.Smalllatchonconnector
should line up and snap into place.
Checkmagnetposition(requiresshroud
removal)
Magnetshouldbeinplaceonflywheel.Ifno
magnet is present, replace the flywheel or the
entirebaseunit(ifunabletoreplaceflywheel).
CheckRPMSensor(requiresshroud
removal)
RPMsensorshouldbealignedwithmagnet
and connected to data cable. Realign sensor if
necessary. Replace if there is any damage to the
sensor or the connecting wire.
Consoleshutsoff(enters
sleepmode)whileinuse
Checkdatacableintegrity Allwiresinthecableshouldbeintact.Ifanyare
cut or crimped, replace cable.
Checkdatacableconnections/
orientation
Makesurecableisconnectedsecurelyand
orientedproperly.Smalllatchonconnector
should line up and snap into place.
ResetMachine(ifequippedwithreset
button)
Unplugunitfromelectricaloutletfor3minutes.
Reconnect to outlet. After the Console powers
up,press“reset”.
Checkmagnetposition(Technician
onlyrequiresshroudremoval)
Magnetshouldbeinplaceonflywheel.Ifno
magnet is present, replace flywheel or entire
base unit.
CheckRPMSensor Contact Customer Care for further assistance.
Fan(ifequipped)willnotturn
on or will not turn off
Checkdatacableintegrity Allwiresincableshouldbeintact.Ifanyarecut
or crimped, replace cable.
Checkdatacableconnections/
orientation
Be sure cable is connected securely and
orientedproperly.Smalllatchonconnector
should line up and snap into place.
ResetMachine(ifequippedwithreset
button)
Unplugunitfromelectricaloutletfor3minutes.
Reconnect to outlet. After Console powers up,
press“reset”.
Unitrocks/doesnotsitlevel Checkleveleradjustment Leveling feet may be turned in or out to level
bike.
Checksurfaceunderunit Adjustment may not be able to compensate for
extremelyunevensurfaces.Movebiketolevel
area.
Pedalsloose/unitdifficultto
pedal
Checkpedaltocrankconnection Pedalshouldbetightenedsecurelytocrank.Be
sureconnectionisnotcross-threaded.
Checkcranktoaxleconnection Crankshouldbetightenedsecurelytoaxle.Be
surecranksareconnectedat180degreesfrom
each other.
Seatpostmovement Checklockingpin Besureadjustmentpinislockedintooneofthe
seat post adjustment holes
Checkadjustmentknob Besureknobissecurelytightened.