Operation Manual

10
3. Install Handlebars on Console Mast
NOTICE: Do not crimp the cables. Put the Handlebar (7) in the bracket (5a), adjust the Handlebar to the desired
angle,andinstalltheT-handle(D)throughtheholes.UsethepullcableintheHandlebarMounttoroute
the HR cable (7a) and Resistance cable (7b) through the slot (5b) under the Handlebar Mount to the top
ofthemastandthroughtheopeningintheconsolemountplate.FullytightentheT-handletokeepthe
Handlebarinposition.Pushthecover(6)intopositionontheHandlebarMount.
7a
7
6
D
E
B
5a
D
E
B
7
5a
D
7a
7
5b
7b
7b