Manual

ManualsBrandsNAV-TV ManualsMobile Rear-View CamerasNAV-TV Back Up Video Interface

BHM

4/5/13

NTV-DOC 031

1 | P a g e

Agreement: End user agrees to use this product in compliance with all State and Federal laws. NAV-TV Corp. would

not be held liable for misuse of its product. If you do not agree, please discontinue use immediately and return

product to place of purchase. This product is intended for off-road use and passenger entertainment only.

9350 NW 120

Ave, Coral Springs, FL 33065 TEL 561-955-9770 FAX 561-955-9760

www.nav-tv.com info@nav-tv.com

BNT kit install manual

The BNT kit allows the ability to add a backup camera and additional video input to the factory

screen in Bentley Continental/GT and VW Phaeton vehicles. This install requires disassembly of

the factory radio and should only be performed by professionals.

1. Remove the factory radio: remove the trim surrounding the radio, then remove 5 screws

that secure the radio into the dashboard. Pull the radio from the dash, disconnect all

connected harness and bring it to a clean bench with a soft surface.

Overview

Installation

Summary of content (4 pages)

PAGE 1
BHM 4/5/13 NTV-DOC 031 9350 NW 120th Ave, Coral Springs, FL 33065 TEL 561-955-9770 FAX 561-955-9760 www.nav-tv.com info@nav-tv.com BNT kit install manual Overview The BNT kit allows the ability to add a backup camera and additional video input to the factory screen in Bentley Continental/GT and VW Phaeton vehicles. This install requires disassembly of the factory radio and should only be performed by professionals. Installation 1.
PAGE 2
BHM 4/5/13 NTV-DOC 031 2. Separate the front half of the radio from the back half by removing 2 torx screws from each side of the radio. 3. Carefully disconnect the ribbon that connects to the screen indicated by the red arrow. Disconnect the other 2 cables indicated by the yellow arrows. 4. Insert the free end of the ribbon from the BNT board into the radio’s display connector (near 2 small caps). Be certain the pins are facing the correct direction, and that it is seated firmly.
PAGE 3
BHM 4/5/13 NTV-DOC 031 5. Connect the free end of the Factory LCD ribbon that was disconnected in step 3 to the other side of the BNT board. 6. Use 3M double sided stick tape (or equivalent measure) to secure the BNT board down to a nearby flat surface. 7. Remove the top metal cover from the back half of the radio. Run the RGB cable (leave slack) on the top, left side of the radio like shown. Use a small zip tie to secure the cable from being pulled. 8.
PAGE 4
BHM 4/5/13 NTV-DOC 031 9. Connect the free end of the RGB cable to the included blue NAV-TV RGB module at the port labeled ‘RGB OUT’. 10. The RGB will need to receive power to pass video. The included barrel power plug must be connected to ground (black wire) and 12v ACC or Ignition (red wire). NAV-TV recommends using the optional S2P module (NTV-KIT334) in situations where a true accessory power is difficult to find.