Installation Manual

BHM
11/21/17
NTV-DOC242
Agreement: End user agrees to use this product in compliance with all State and Federal laws. NAV-TV Corp. would not be held liable for
misuse of its product. If you do not agree, please discontinue use immediately and return product to place of purchase. This product is
intended for off-road use and passenger entertainment only.
5 | P a g e
8. Install your reverse camera and run signal, power and ground wires up front to the AUDI
interface from step 7.
9. Power your camera with an ACC source or the purple 12v reverse output wire (500 mA
MAX). Find a solid ground (-) for the camera as well. NOTE: if using KIT381 (AUDI handle
cam), cut off the connector and use black wire for ground and red for power.
10. Connect the signal for your camera to the yellow RCA among the Power/CAN Harness
labeled ‘CAMERA’.
11. Connect the 24-pin white plug from the Power/CAN Harness to the port on the AUDI-
DYN INT interface labeled ‘POWER/CAN’.
12. Start the car and test for proper functionality before replacing dash pieces. If menu
adjustments are needed (to remove sensor overlay, etc.), proceed to ‘Menu
Adjustments’
Note: All other included harnesses not mentioned in this manual are not needed for most
installations. If you would like to know more about the full capability of this interface, contact
NAV-TV tech support at 561-955-9770. Additional features not mentioned in this manual are not
supported by NAV-TV at this time.