Owner's Manual
TY
12/28/21
NTV-DOC314C
4 | P a g e
ZEN-V General Installation Notes
• This interface can be installed in vehicles with or without an amplifier & with or without MOST fiber
optic presently installed.
1. Vehicles with fiber amplifier: the amplifier must be removed (unless it is MIB3.) Connect the OEM
fiber previously connected to the amp, directly into the ZEN-V.
2. Vehicles without OEM amplifier or MOST fiber: Use the supplied fiber optic extension and
connect from the fiber port behind the radio/MMI to the MOST fiber port on the ZEN-V. NOTE: If the
vehicle does not possess an OEM amplifier, you must program the system for external amplifier
for the ZEN-V to operate properly. Use a VAG-COM or NAV-TV’s ZEN-V-PRG programmer (NTV-
Kit861 sold separately). For an MIB3 System, only the MIB Programmer (NTV-Kit 996) must be used.
3. Vehicles with MIB3 or without an amplifier but still equipped with fiber: Disconnect the fiber from
the radio, disassemble the fiber coupler and route the provided MOST extension into the factory
MOST loop as shown below (to continue proper MOST data flow):
*NOTE: in this scenario, the vehicle still must be programmed for external amp (see red note
above).
• Tuning tips:
1. Before beginning tuning process (especially with external EQ/Processors), set Bass & Treble on
the head unit for each source to flat (0).
2. Begin with amplifier/EQ gains all the way down.
3. With dynamic music playing, adjust the radio volume to maximum.
4. Adjust the amplifier/EQ gains to desired maximum level.
• From the factory, some vehicles’ audio will attenuate when in reverse. Simply set the ‘reverse volume’
to desired level while in reverse to adjust this. The ZEN-V will retain this method. The same is true for
NAV guidance audio and BT voice calls.