Owner's Manual

ManualsBrandsNavAtlas ManualsATV & UTVPTS1

INSTALLATION

OWNER'S

MANUAL

PTS1

Smart

Key

Smartest

way

start

your

UTV/ATV

Push-to-Start

keyless

System

for

your

UTV/ATV

makes

starting

you

vehicle

safe

and

convenient

Navntlas™

Summary of content (8 pages)

PAGE 1
INSTALLATION I OWNER'S MANUAL PTS1 Smart Key Smartest way to start your UTV/ATV Push-to-Start keyless System for your UTV/ATV makes starting you vehicle safe and convenient Navntlas™
PAGE 2
Contents 1. Product and its accessory 2. How to start the engine and use Fob Key 3. How to Register Fob and cancel Fob key 4. Wire Connection/Installation 5.
PAGE 3
PTS1 Smart Key 1.
PAGE 4
PTS1 Smart Key 2. How to start the engine and use Smart Key 1. How to start engine When SSB is pressed more than 1 seconds with the FOB in range of the receiver, engine will turn on or off. 2. ACC ON/ OFF Once SSB button is pressed down less than 1 second, ACC will turn on/ off. (If you push down SSB button more than 1 second while ACC is on, engine will start at that moment and SSB will turn off) 3.
PAGE 5
PTS1 Smart Key _,,.,____,""'"~-_ _ -~'-'-~"-"-'""'"'-"" ""',._~,,~,..,-~,,_,,,,,_.,.,_-,.~,..-,,"""-"'""'---..,'-"'"-"""'"'""'=-"'-"-"''n~'-""""""''~·"""-''""""""'"-''""""~""""""'-"'"''''''"~-..,_.,.o"''"-"'·'."•'C'-'"'"''"''"""'"''~'-"""'""'"'""·''"'"~""=~•_.'''=·"'""""~'"""''-""''''"·~--"~'""'-"'·"-"-''"''F~·' ..,_--.~.._.,._.<>',._.,,,_.~,_.~~--•"-,_-~_.,.,,._,_._o"<:"'--"--..,··~-•"-"""-''"'"-"''--"'·~·"~''-'-"''~'"""''.,..._'""--.,_'.. _._. .. _00"_.--'_..~""''-""'"'''"''"" 3.
PAGE 6
PTS1 Smart Key 4. Wiring connection * Please refer to the pictures. 1. Connect SSB/PDM module wires to same colored connecting wires of control module. * Make sure to match wire to wire with same colors. Otherwise, it may cause the damage to the product. 2. Connect PDM module wires to same colored connecting wires of UTV/ATV.
PAGE 7
PTS1 Smart Key 5. How to change the battery of Fob key Battery normally can be used for about 2-3 years, however if needed, change the battery. 1. Open the cases of Smart key by using small coin. 2. Replace it with one CR2032 battery. Pis make sure of polarity(+,-). 3. Assemble it again in the same way you opened it. 4. When a new battery is replaced, make sure Fob key works, in some cases it may need to be registered again.
PAGE 8
NavAtliiS™ www.navatlas.net ©2016 Namsung America Inc. 250 International Pkwy, Heathrow, FL 32746 Specifications are subject to change without notice. All trademarks are the property of their respective owners.