User's Manual

16
|
Installation | Broadband 3G™ Radar Installation Guide
Shortening the cable
It is not recommended to shorten the cable, but if it is essential, use the pin-out below to re-
terminate the RJ45 connector
RJ45 Connector
RJ45 crimping tool is required Pin Color
P1P8
1 White/Orange
2 Orange
3 White/Green
4 Blue
5 White/Blue
6 Green
7 White/Brown
8Brown
RJ45 Connector 15 mm Heat shrink (10 mm dia)
Mounting the radar interface box
Install the radar interface box (where applicable) in a dry location away from spray, rain, drips
and condensation.
The radar interface box must be located where it can be easily connected to the ship’s power
source, the scanner interconnection cable, SimNet/NMEA2000 and the display or display
network.
Allow enough room for cables to form a drip loop.
Preferably mount the radar interface box on a vertical surface with cables exiting downwards.
Insert connectors . See “Connect the interconnection cable to radar interface box” on page
15.
Secure to the surface using the four mounting points.