User's Manual

14 |
Hardware mounting |Halo pulse compression radar installation manual
Pole or tower mount: Discreet cable connection
The interconnection cable can be optionally connected discreetly underneath the pedestal by
moving the 14 pin connector at the rear of the pedestal to a bracket underneath the pedestal.
1. Remove the retaining nut and pull back the connector and  y lead.
2. Fit the supplied blanking plug where the connector used to be.
 Note: The blanking plug is attached the bracket underneath the pedestal.
3. Re-route the internal  y lead to the bracket and secure with the nut.
4. Connect the interconnection cable. Take care to align the connector correctly to avoid bending
the pins. Secure the locking collar by rotating clockwise until it clicks
5. Lower the pedestal carefully over the bolt holes so that they are aligned.
6. Place a  at washer and spring washer onto each bolt, as shown.
7. Insert bolts into the drilled holes and locate into the pedestals threaded mounting holes and
tighten securely.
Draft_08_April_2015