User's Manual

20 |
Wiring |Halo pulse compression radar installation manual
Connecting power
1. Strip away approximately 10 mm (0.4” ) of the insulation at the end of each core of the power
cable
2. Unscrew the retention screw from the positive input connector (identi ed by the + sign) on the
radar processor
3. Insert the bare end of the positive wire into the positive power cable input connector to make
a connection
4. Tighten the holding screw to hold the positive wire in place. Gently pull on the positive wire to
ensure that it is secured
5. Repeat this process to connect the negative wire to the negative power cable input connector
(identi ed by the – sign)
+
_
12 or 24 V DC
Draft_08_April_2015