User's Manual

26 |

Setup and con guration |Halo pulse compression radar installation manual

When all connections have been made and checked the safety switch on the rear of the

pedestal can be set to the ON position

Setup and con guration

Setup and con guration of the Halo® radar has been simpli ed compared to traditional pulse

radars. There is no zero range adjustment (time delay), no warm up time, and no burn in

required.

Source

On the radar page, choose the radar to be setup using the source drop down. MENU>SOURCE

When setting up the Halo Pulse Compression radar choose either Halo-A or Halo-B is selected

 Note: following settings require the radar to be in Transmit mode. MENU>TRANSMIT

Entering radar setup on your display

Enter radar installation by pressing MENU > SETTINGS > RADAR > INSTALLATION.

Select the antenna length

Select the correct length of antenna. Select Save to exit back to the radar installation page.

Draft_08_April_2015