User's Manual

| 27
Setup and con guration | Halo pulse compression radar installation manual
Adjust antenna height...
Set the radar scanner height. Use the slider control or the “+” or “-” buttons to set the value then
SAVE.
 Note: It is very important to set the antenna height con gured correctly as this will a ect the
sea clutter function. Do not set the height to 0.
Adjust bearing alignment...
Adjust the heading marker. This is to align with the heading marker on the screen with the
center line of the vessel, this will compensate for any slight misalignment of the pedestal during
installation. Any inaccuracy will be evident when using MARPA or chart overlay.
Point the boat to the end of a head land or peninsula. Adjust the bearing alignment so the
heading line touches the end of the same head land or peninsula.
Use the slider control or the “+” or “-” buttons to set the value then SAVE
Draft_08_April_2015