User's Manual

Initial Configuration
23
If you decide not to enter your MMSI at this stage, it can be entered later
from within the System setup menu, refer to section 5.6.3. However, you
will not be permitted to enter any other information about your vessel
until MMSI entry has been completed.
Note Your AI50 will only operate as a receiver, until you have fully completed
the ship configuration as described in Section 4.3.
4.3 Ship Confi guration Procedure
From the Display Mode, press the  MENU key to enter Menu Mode.
Scroll down the displayed menu using the ▼ key to “System Setup”, and
press  MENU or ►.
Scroll down the system setup menu using the ▼ key to “Ship
Configuration”, press  MENU or ►. A more detailed procedure is
explained from section 4.3.1 onwards.
All values selected during this procedure will be automatically stored in
the AI50 memory once completed.
WARNING
All data entered during this procedure can be edited at any
time, except the MMSI. Once this has been entered and
confirmed it will become locked and shown as greyed out.
Indicating that it can be viewed, but not edited.
Should it become necessary to change your MMSI, for example, if you
wish to re-install your AI50 into a new vessel; you will need to contact
your local Simrad dealer about reprogramming a new number.
4.3.1 MMSI Entry
If you have selected "YES" when asked to “Configure Now”, a warning
window will appear Fig. 4.5.
Press the ◄ key to clear the message and continue. The warning disappears
from the screen and you are now ready to enter your MMSI number Fig. 4.6.
Fig. 4.5 – MMSI Entry warning